jaswebhosting.blogg.se

With an interval setting of 10 seconds there is an API call every 5 seconds (and with Waterflow enabled, every 3.33 seconds).

The P1 Monitor QuickApp uses 2 API calls each cycle, and if you also use Waterflow, 3 API calls each cycle. Older or other RPIs have not been tested. It has been tested on the Rpi3/Rpi4 and works well on it. Note that this gives a higher load on the Rpi (or Docker). This can be turned on via the ztatz software P1 port configuration page via the "maximum processing speed" option. Of course, this is only possible if the smart meter actually sends a message every second. It is possible to process messages from the smart meter every second. Todays Production (kWh) (input for energy panel).Todays Consumption (kWh) (input for energy panel).Production (Watt) (input for instantaneous power in Energy Panel calculations).Consumption (Watt) (input for instantaneous power in Energy Panel calculations).Use the child devices Todays Consumption and Todays Production to store energy data (kWh) in the Energy Panel.Īnd use the child devices Consumption and Production for instantaneous power (Watt) in the Energy Panel calculations. The Energy consumption and energy production are added to the HC3 energy panel. The ztatz plug-and-play software can run on a Raspberry Pi or in a Docker container. This Quickapp uses the software of to get the values from your smart energymeter. This Quickapp retrieves energy consumption, energy production, gas and water usage from the (P1 Monitor) energy, gas and water meter.